Replaced tenants stairs

Howd i do? Cut it completely freehand. Its hard to tell but theres a slab under the bottom plate.

Whats crazy is whoever built the deck didnt attach it to the joist but a 1x3 trim that held the little "decorative" siding piece...

250 Piece Survival Gear First Aid Kit

LifeStraw Water Filter for Hiking and Preparedness

250 Piece Survival Gear First Aid Kit

  1. 1 year ago
    Anonymous

    >Cut it completely freehand
    Freehand meaning what, you didn't follow a straight edge?

    • 1 year ago
      Anonymous

      Circular saw, no jig or anything

      Pressure treated lumber for the frame and composite for the surface is the way to do it. That stuff lasts forever. My deck is 15 years old and the only damage on it is holes from a rogue woodpecker. It's more expensive upfront but it's cheaper in the long run because you build it once and never have to mess with it again.

      Tbh i plan on gutting the entire deck in a couple years so its temporary.

      https://i.imgur.com/XZhky32.png

      What is it sitting on? If that's concrete it's fine, but if that's sand it's no good as it's just going to erode away with rain.

      It's pressure treated, it will be fine for a while, maybe 8-10 years.

      [...]
      Seconding this. You need to put another support board under the back of the stringer. Just having it supported under the front puts a ton of stress at the narrowest point of the stringer, at the back of the lower tread.

      I bought gravel and compacted it as best i can. Its hard to tell but the bottom plate is sitting on a slab, its making good contact other than the end

      no you don't....
      the only thing that matters is it needs to be attached nicely to whatever deck is there

      Don't see any nails into the stringer, didn't use brackets

      I used pic related and used joist nails to attach it. Also used deck screws and toe nailed (screwed) them in to the joist.

      • 1 year ago
        Anonymous

        >no jig or anything
        Not shitting on you or anything, but I don't think anyone uses a jig for that

        • 1 year ago
          Anonymous

          Pretty much. All you'd really need for that is a tape measure and a speed square.

        • 1 year ago
          Anonymous

          Last time I did stringers for 8 steps, I picked up a pre-cut three step piece to use as a template. It was nice. No thinking required.

  2. 1 year ago
    Anonymous

    did you have to seal that wood at all?

    • 1 year ago
      Anonymous

      What is it sitting on? If that's concrete it's fine, but if that's sand it's no good as it's just going to erode away with rain.

      It's pressure treated, it will be fine for a while, maybe 8-10 years.

      Those runners should lay flat on the concrete. It's fine, but what I would do is get another piece of wood to fill in the rest at the bottom because eventually it will split right at the first riser where there's nothing under it. Couple shingles under it to prevent it from wicking might be nice too if you have any on hand.

      Seconding this. You need to put another support board under the back of the stringer. Just having it supported under the front puts a ton of stress at the narrowest point of the stringer, at the back of the lower tread.

      • 1 year ago
        Anonymous

        no you don't....
        the only thing that matters is it needs to be attached nicely to whatever deck is there

        Don't see any nails into the stringer, didn't use brackets

  3. 1 year ago
    Anonymous

    It's decent enough, normally you go 2x thicker joists than the landings but it's so short you could get away with plywood here. Also free hand isn't a bad idea for steps, it's fast and you're bound to have sloping which will prevent water pooling. Just don't paint the fricker.

  4. 1 year ago
    Anonymous

    Pressure treated lumber for the frame and composite for the surface is the way to do it. That stuff lasts forever. My deck is 15 years old and the only damage on it is holes from a rogue woodpecker. It's more expensive upfront but it's cheaper in the long run because you build it once and never have to mess with it again.

  5. 1 year ago
    Anonymous

    Those runners should lay flat on the concrete. It's fine, but what I would do is get another piece of wood to fill in the rest at the bottom because eventually it will split right at the first riser where there's nothing under it. Couple shingles under it to prevent it from wicking might be nice too if you have any on hand.

  6. 1 year ago
    Anonymous

    I don't know if you live in a desert perhaps in which case it would be fine, but in a wet environment I would put asphalt or something across that because water would sit on it and rot it or freeze and in about two years your tenant would be suing you for a broken ankle.

  7. 1 year ago
    Anonymous

    Add a railing

    • 1 year ago
      Anonymous

      Code says i dont need a railing if its under 30 inch. Total rise plus tread is only 22 inches

    • 1 year ago
      Anonymous

      Railings aren't required unless there's more than a 30" height difference.

  8. 1 year ago
    Anonymous

    Wish i took better pics before i gutted the old ones.

    Whoever installed them used nongalvinized nails and cheap non galv joist hangers. And nailed it to a non pressure treated 1x3 pine board trim. Im surprised it didnt collapse and hurt the mailman. I wiggled it free with my pointer finger.

    Dont get me wrong, im moronic but frick man. I dont want to own anything unless i build it myself, buying property really fricked with my trust issues after all the shit ive uncovered.

    • 1 year ago
      Anonymous

      >buying property really fricked with my trust issues after all the shit ive uncovered
      I'm so scared of buying a house man.

      • 1 year ago
        Anonymous

        >old owner replaced the water heater himself
        >copper pipe to steel water heater
        >transition fitting still in its box on the ground next to it
        >so much corrosion on the union that it looks like a green miniature Elephant's Foot
        i'm sure i'll frick up something like that for the next owner too, but goddamn pre-youtube DIY jobs are nightmares more often than not

      • 1 year ago
        Anonymous

        Dont do it. Build. The amount of spawlling in ne basements ive seen is sad. Not one person has water proofered their stem wall. Its mind blowing these properties actually go up in value.

    • 1 year ago
      Anonymous

      >buying property really fricked with my trust issues after all the shit ive uncovered.
      This is the life lesson about everything. You really don't want to see how the sausage is made.

  9. 1 year ago
    Anonymous

    Since its for a rental property you should probably put in toe kicks.

    • 1 year ago
      Anonymous

      should put those rubber traction treads on it
      wood gets slippery in the winter and every dead beat is hoping for a payout

Your email address will not be published. Required fields are marked *