Following a comprehensive review and analysis of the supplied documentation, I hereby express my concurrence with the veracity of the aforementioned statement. This thorough perusal, conducted with meticulous attention to detail, has led me to the conclusion that the content in question aligns with factual accuracy. It is imperative to underscore the diligence employed in this examination, ensuring a comprehensive understanding and acknowledgment of the accuracy inherent in the stated proposition.
>Doing pretty good on a 3f v-groove >All of a sudden the weld pool goes all moronic and 10 minutes of precise tacking goes out the window.
Why must you do this to me 7018? You're supposed to be the good one.
Its pretty bad. try doing some manipulation with your torch if youre having trouble keeping a consistent travel speed. little circles or a very slight side to side helps a lot with staying consistent
looks either a little cold or that you were a bit slow on it, and there's a lot of spatter. Maybe tune in your machines settings a bit more or work on your manipulation.
I've seen better, but I've also seen way worse... 6/10.
Voltage might be a bit high, lots of splatter. Good enough/10.
What equipment are you using? Separate thread but related, since you brought up the welding subject.
That is a weld.
After a moderate perusal of the provided material, I can concur that this statement is correct.
Following a comprehensive review and analysis of the supplied documentation, I hereby express my concurrence with the veracity of the aforementioned statement. This thorough perusal, conducted with meticulous attention to detail, has led me to the conclusion that the content in question aligns with factual accuracy. It is imperative to underscore the diligence employed in this examination, ensuring a comprehensive understanding and acknowledgment of the accuracy inherent in the stated proposition.
nothing exceeds like excess, anon
I think your weld has an STD
There called “STI”s now.
Looks like hammered dog shit but it also looks solid. Not terrible.
*they’re
They/them*
I like the bit between the red lines
that's not a weld, that's a welp.
look at all those ladybugs
Weld straight. You're using a welder where all you do is pull a button.
>Doing pretty good on a 3f v-groove
>All of a sudden the weld pool goes all moronic and 10 minutes of precise tacking goes out the window.
Why must you do this to me 7018? You're supposed to be the good one.
moist sticks?
Not ideal, but, I've done worse.
raise the amps a bit
hit that with the old grinder and it will be looking like you knew what you were doing in no time at all
Have another beer
Its pretty bad. try doing some manipulation with your torch if youre having trouble keeping a consistent travel speed. little circles or a very slight side to side helps a lot with staying consistent
Sevendy Dolar
looks either a little cold or that you were a bit slow on it, and there's a lot of spatter. Maybe tune in your machines settings a bit more or work on your manipulation.