I tried drilling this nail for my sofa bed with this and it wont drill far enough should i get a new stronger drill or i messed up?
I tried drilling this nail for my sofa bed with this and it wont drill far enough should i get a new stronger drill or i messed up?
Just unscrew it a bit and push it harder inside afterwards, mang
This is as far as it goes
Bolt, whatever
English is my 3rd language
Open up the manual and find the instructions for the clutch in whatever your preferred language is.
The black ring that goes from 1-15, turn it past 15+ to the little drill symbol.
>drilling
>nail
Grab a screwdriver and turn it the old fashioned way.
Pre=drill a hole with a drill bit around the size of the screw shaft. Not as wide as the threads, just the shaft.
Have you adjusted the torque limiter? Cuz even shittiest drill should do it
Even the best drill can't overcome the limitations of Philipshit
lmfao
I saw this Hyper Tough 8V cordless drill for sale on Walmart's website today for $10. A ten dollar drill! That's hilarious. What a world.
It will be able to drill a hole then drive a screw in, for OP's once every few months projects.
I think the problem is OP had no handyman father figures growing up.
now look 'ere young man, back in my day a good quallidy drill made in 'Murrica cost just 5 dollas an 69 cents
link because damn I could use a $10 drill
I was refinishing my basement and needed a hammer drill to lag the plate to the concrete. Went to harbor freight and bought a $12 hammer drill. It was a complete pile of garbage and was smoking by the end of it but got the job done. $12 well spent. Tossed that shit in the garbage afterwards.
I wonder if a 70 dollar drill can drill 7 times more.
HYPER
SHIT