I have this snapper mower. The spark plug cable is trashed.

I have this snapper mower. The spark plug cable is trashed. It's part of this other pieces that doesn't look cheap. What do I need to replace? Can I just trim the cable and attach a new head? Crimping tool might be cheaper

  1. 3 weeks ago
    Anonymous

    >Can I just trim the cable and attach a new head?
    Yeah. Looking at your picture, the cable looks OK except for the clip on the spark plug. Just buy new parts at auto parts shop, trim cable and crimp on. It looks like you have enough slack to make a new connection at the plug end.

    Try to avoid cutting the existing cable too close to the magneto. The high voltage termination there is potted and a couple of screwed up splice attempts and you'll need to replace that whole a$$embly.

    • 3 weeks ago
      Anonymous

      Ok. Will do.

      This one will run fine for about 5 minutes then start to slow down, bogs down, and then I cant start it again. No ignition. Has spark but it leaks around the cable

      • 3 weeks ago
        Anonymous

        magnetos are cheap, buy a new one.

      • 3 weeks ago
        Kevin Van Dam

        >bogs down
        Check your fuel lines too. The rubber lines tend to get brittle and crack. When I have those symptoms on other small engines, it’s often the fuel lines or sometimes a leaky primer bulb because the lines have enough fuel to get the carb wet and run it for a couple minutes and then it starves as the air gets sucked in the cracks and it dies.

  2. 3 weeks ago
    Anonymous

    >It's part of this other pieces that doesn't look cheap.
    I guess that depends on what your definition of "cheap" is.
    If you do replace it, you'll want to be sure to align and space it correctly ... put a thin card between the magneto and the flywheel rotor when you tighten down the magneto, that's about the right amount of gap.

    • 3 weeks ago
      Kevin Van Dam

      >thin card
      Are you talking playing card or business card or Speedy Rewards card or credit card?

      • 3 weeks ago
        Anonymous

        Unless you've got a set of feeler gauges and know what the correct spec should be, which obviously would be more precise, a business card or playing card gets you into "close enough" range.

        • 3 weeks ago
          Bepis

          Ahh I have the feeler gauges, I didn’t use them the last time I changed an ignition coil. I just put it up against the flywheel and barely backed it off so it spun free and she ran good.

          Amazon parts don’t come with gap instructions.

          • 3 weeks ago
            Anonymous

            >Amazon parts don’t come with gap instructions.
            Mine did, bought cheap from Amazon, it literally said to use "a business card"

            • 3 weeks ago
              Bepis

              In all fairness, there may have been chinglish instructions that I promptly threw into the ocean.

    • 3 weeks ago
      Anonymous

      are these all the same or model specific?, i see a ton of different numbers

  3. 3 weeks ago
    Anonymous

    Try not being poor and buying a good mower.

Your email address will not be published. Required fields are marked *