how would you repair this? and how is the proper way to repair it?

how would you repair this? and how is the proper way to repair it?

250 Piece Survival Gear First Aid Kit

LifeStraw Water Filter for Hiking and Preparedness

250 Piece Survival Gear First Aid Kit

  1. 1 month ago
    Anonymous

    Turn it into a cybertruck logo engraving

  2. 1 month ago
    Anonymous

    Compress it with a warm wet towel

  3. 1 month ago
    Anonymous

    Replace the board

    • 1 month ago
      Anonymous

      >how would you repair this?
      Replace it.
      >and how is the proper way to repair it?
      Replace it.

      Easy: Replace whole board. Plunge cut with multi tool and fit new board in place.

      Better: Get laminate of matching wood, route out and chisel off a thin layer slightly less than the thickness of the laminate and glue your laminate to it. Sand until level with surrounding boards and apply finish.

      Just flip it over, duh.
      >turns out someone did that 30 years ago

  4. 1 month ago
    Anonymous

    >how would you repair this?
    Replace it.
    >and how is the proper way to repair it?
    Replace it.

  5. 1 month ago
    Anonymous

    Superglue, crushed ramen noodles and a sharpie

    • 1 month ago
      Anonymous

      For me it's sunflower seeds

  6. 1 month ago
    Anonymous

    Easy: Replace whole board. Plunge cut with multi tool and fit new board in place.

    Better: Get laminate of matching wood, route out and chisel off a thin layer slightly less than the thickness of the laminate and glue your laminate to it. Sand until level with surrounding boards and apply finish.

  7. 1 month ago
    Anonymous

    Either I'm moronic, blind, or both, but that looks like it's just sawdust sitting on top of the wood.
    Couldn't you just sand it flat? I can't tell if that's sticking up or if it's a crater in the board.

    • 1 month ago
      Anonymous

      ?
      maybe you need to get ur eyes checked
      those are obvious gouges from moving some appliance around

      • 1 month ago
        Anonymous

        >maybe you need to get ur eyes checked

        Long-time floor guy here. It's sawdust. I can't tell you how many times I've been called for a floor refinishing estimate just to tell the homeowner to sweep up the sawdust.

    • 1 month ago
      Anonymous

      i saw that too, took a good minute to unsee it.

      • 1 month ago
        Anonymous

        Actually it seems that these three are always right side up. Also, in GIMP you can flip the image and sometimes they go back to being upside down so you can experience it again.

        This one isn't as annoying as that ballerina thing that spins one way for a while then goes the other way.

  8. 1 month ago
    Anonymous

    Try a wet towel and heat, some of it might spring back

  9. 1 month ago
    Anonymous

    tasteful rug time.

  10. 1 month ago
    Anonymous

    Water caused a dent or damage to swell. Refinish it. Tape it off, sand it, and a few coats of poly.

Your email address will not be published. Required fields are marked *