Can you really just shove zip ties into a hot glue gun to make a poor mans 3D printer?

Can you really just shove zip ties into a hot glue gun to make a poor mans 3D printer?

250 Piece Survival Gear First Aid Kit

LifeStraw Water Filter for Hiking and Preparedness

250 Piece Survival Gear First Aid Kit

  1. 11 months ago
    Anonymous

    No you fricking moron what kind of question is that

    I dont know maybe

  2. 11 months ago
    Anonymous

    I doubt it would feed correctly with the trigger, you'd probably have to push them by hand. Watch for fumes, zip ties might be abs plastic.

    • 11 months ago
      Anonymous

      >zip ties might be abs plastic
      they're all made of nylon idiot

      • 11 months ago
        Anonymous

        >lol this guy doesn't know the specific chemical composition of zip ties? What an idiot!!!

        • 11 months ago
          Anonymous

          Basically, if you want to talk about something but don't understand what you're talking about then shut up.

          • 11 months ago
            Anonymous

            Stay mad, homosexual

            • 11 months ago
              Anonymous

              >noooo you can only talk about stuff if you have a PhD in the subject with a masters in debating to go along with it
              Go back to r*ddit

              Your solution to not knowing stuff is talking out your ass and hoping you're right, then getting mad at whoever proves you're not. Do you have a bicep where your brain should be?

          • 11 months ago
            Anonymous

            >noooo you can only talk about stuff if you have a PhD in the subject with a masters in debating to go along with it
            Go back to r*ddit

            • 11 months ago
              Anonymous
        • 11 months ago
          Anonymous

          >Lol this guy's never actually bought or used zip ties
          Sorry about your learning disability.

      • 11 months ago
        Anonymous

        how naive can you be

  3. 11 months ago
    Anonymous

    if you want to repair plastics use a hot stapler or buy a 3d printed pen.

  4. 11 months ago
    Anonymous

    did you save that pic from pinterest? I swear I seen that exact same image on there

  5. 11 months ago
    Anonymous

    Just get a 15 dollar Ali 3D pen

    Those actually work

  6. 11 months ago
    Anonymous

    pretty common method in car body shops for repairing plastics. I did the same to plastic weld a kayak, need to prep it well is all..

  7. 11 months ago
    Anonymous

    >zip ties
    >poor man’s
    Have you seen the cost of 11 inchers lately?

    • 11 months ago
      Anonymous

      Your mom doesn't pay anything for my 11 incher.

      • 11 months ago
        Anonymous

        Clean up your life you stupid homosexual

        • 11 months ago
          Anonymous

          No reason to be a dick

        • 11 months ago
          Anonymous

          But sir, is your mother not a woman? I cannot vouch for his intellect, but a homosexual would not select a woman for intercourse!

      • 11 months ago
        Anonymous

        hehehehehe

      • 11 months ago
        Anonymous

        >Your mom
        oooooh he talm bout yo momma!

  8. 11 months ago
    Anonymous

    Buy a vintage soldering iron, one heated with a blow torch

  9. 11 months ago
    Anonymous

    I'm going to try this tomorrow to piss off my boss by ruining his glue guns.

Leave a Reply to Anonymous Cancel reply

Your email address will not be published. Required fields are marked *